Had my erg for 1 year, what maintenance should I do now?
Had my erg for 1 year, what maintenance should I do now?
I bought my Model D erg last desember, and I have turned out to be the best piece of training equipment I ever bought. Not sure how many miles I have on it, but I'm rowing every other day and really enjoying the experience. So fare I have only cleaned the rail the seat slides on, and oiled the chain. After one year of use, is it time to clean out the fan? I see Concept recommend using a vacum cleaner to clean out the fans, would I risk doing damage to anything in there using a compressor and clean it out with pressurized air? I find this usually gets out alot more junk compared to the vacumcleaner, but I'm unsure how robust the fans are.
Re: Had my erg for 1 year, what maintenance should I do now?
Dust is a great boon to the erger, sooner or later the drag factor drops to the right level. However if below 130 on damper 10 (or if there's vibration) it needs cleaning.
I wouldn't use compressed air, it'll blow dust all over the house. Pity to spread it out when you made such an effort to collect it. If the vac with a brush on the end is not enough, use a smaller brush between the blades, the dust there can pack quite hard.
I wouldn't use compressed air, it'll blow dust all over the house. Pity to spread it out when you made such an effort to collect it. If the vac with a brush on the end is not enough, use a smaller brush between the blades, the dust there can pack quite hard.
08-1940, 179cm, 83kg.
- Citroen
- SpamTeam
- Posts: 8036
- Joined: March 16th, 2006, 3:28 pm
- Location: A small cave in deepest darkest Basingstoke, UK
Re: Had my erg for 1 year, what maintenance should I do now?
You won't have enough dust to need a compressor or a vacuum cleaner.
Just loosen the screws, don't remove them, disconnect the clip that holds the ends of the mesh together and you can slide the mesh out. That makes it a much easier job than a full scale cleaning.
Just loosen the screws, don't remove them, disconnect the clip that holds the ends of the mesh together and you can slide the mesh out. That makes it a much easier job than a full scale cleaning.
Re: Had my erg for 1 year, what maintenance should I do now?
Check the PM battery status and the U-bolt wear on the handle. You can meassure it with a calliper and compare it with the part of the bolt that is not exposed for wear.
Even if you use the concept 2 everyday, you can't wear it out if you take care of it.
Even if you use the concept 2 everyday, you can't wear it out if you take care of it.
Age: 33yrs. Hgt: 193cm. Wgt: 100kg.
ModelD:
SkiErg :
ModelD:
SkiErg :