Hello,
After I place the ergo on slides I have mach noise special from the frond slide what can I do, any Ideas??
Thank you
Slides -noise
- PaulS
- 10k Poster
- Posts: 1212
- Joined: March 16th, 2006, 12:07 pm
- Location: Washington State, USA
- Contact:
Check to make sure all the wheels are running on the plastic tracks, along with the aligning mentioned earlier.manos wrote:scrapingPaulS wrote:What type of noise? Thumping, bumping, scraping?
Make sure that the Slides are aligned with eachother precisely.
If you pull the whole machine and carriages to one end and let it go, does it occilate back and forth and stop in the middle, or get hung up along the way?
If it's not obvious, give C2 a call and they probably have some more methodic diagnostic procedures.
Erg on,
Paul Smith
www.ps-sport.net Your source for Useful Rowing Accessories and Training Assistance.
"If you don't want to know the answer, don't ask me the question."
Paul Smith
www.ps-sport.net Your source for Useful Rowing Accessories and Training Assistance.
"If you don't want to know the answer, don't ask me the question."
Thank you very mach I go to follow your advicePaulS wrote:Check to make sure all the wheels are running on the plastic tracks, along with the aligning mentioned earlier.manos wrote:scrapingPaulS wrote:What type of noise? Thumping, bumping, scraping?
Make sure that the Slides are aligned with eachother precisely.
If you pull the whole machine and carriages to one end and let it go, does it occilate back and forth and stop in the middle, or get hung up along the way?
If it's not obvious, give C2 a call and they probably have some more methodic diagnostic procedures.
Regards from Ctete_Chania
Manolis