Dec 2021 firmware released for PM5

[Tonyg]

since updating firmware I have noticed a couple of issues:
My interval session didn't upload correctly using ergdata, should have been 40min v1:00/3:00r...10 instead it was v1:00/3:00r...9 row

Also some of the data looks very odd on the v interval - when I zoom into it via strava the recorded
power is zigzag jumping from as low as 98 to avg 170
Hr is Zigzag 102 to 120
on the last session only happened on one interval, previous days session it happened on three intervals

[Citroen]

Have you upgraded a second time to the bugfix version?

• Indoor rowers
  • Version 210 (released December 2021—for hardware version 900 and higher)
  • Version 171 (released December 2021—for hardware version 600 to 700)
  • Version 32 (released December 2021—for hardware version below 600)
• SkiErgs
  • Version 910 (released December 2021—for hardware version 900 and higher)
  • Version 871 (released December 2021—for hardware version 600 to 700)
  • Version 732 (released December 2021—for hardware version below 600)
• BikeErg
  • Version 361 (released December 2021—for hardware version 900 and higher))
  • Version 329 (released December 2021—for hardware version 600 to 700))

If you have, then write an email to rowing@concept2.com with details of how to recreate your "zigzag jumping".

[Tonyg]

Have you upgraded a second time to the bugfix version?

If you have, then write an email to rowing@concept2.com with details of how to recreate your "zigzag jumping".

Many thanks for the advice, I do have the latest firmware 171 installed, I will email as you have advised,
recreate would be set as:

• Turn on PM5
• Turn on Ergdata - Connect
• Rerow
• Intervals as per previous set
• Use PolarH10 Chest Belt
• Start exercise

Fingers crossed. Reading through some posts it appears intervals seem to have ongoing issues with ergdata and strava. I have different totals for each part of the chain for the same activity;
PM5 gives correct info
Image on strava - different totals
Data on strava - different to both Image and PM5

[wivku]

the release notes for the December 2021 firmware states:

Addition of Bluetooth firmware update capability

Suggestions of what this means/does?
Does this make it possible to update the PM firmware over bluetooth? From ErgData?