Rowit with windows7
Posted: October 7th, 2013, 8:14 pm
tried using RowIt for the first time on windows7. I get the "Error: Invalid port number was specified".
any suggestions?
any suggestions?
Page 1 of 1
Re: Rowit with windows7
Posted: October 8th, 2013, 1:13 am
I've seen that too, with W7 starter, but if you connect up before switching on it usually works.
Re: Rowit with windows7
Posted: October 8th, 2013, 9:41 am
Ill try that tonight.
I figured it had something to so with the way windows7 identifies USB ports vs xp and or vista.
I figured it had something to so with the way windows7 identifies USB ports vs xp and or vista.
Re: Rowit with windows7
Posted: October 8th, 2013, 7:36 pm
Got home and tried your trick. It worked without a hitch. However I noticed when I went to use the concept2 utility that I needed to unplug the USB cord and reinsert to get the utility to recognize the PM3.The two pieces of software must utilize different ports or something. I am no software engineer i can tell you that. 