Page 1 of 1
Slides -noise
Posted: February 2nd, 2007, 6:45 am
by manos
Hello,
After I place the ergo on slides I have mach noise special from the frond slide what can I do, any Ideas??
Thank you
Posted: February 2nd, 2007, 9:28 am
by PaulS
What type of noise? Thumping, bumping, scraping?
Make sure that the Slides are aligned with eachother precisely.
Posted: February 2nd, 2007, 5:18 pm
by manos
PaulS wrote:What type of noise? Thumping, bumping, scraping?
Make sure that the Slides are aligned with eachother precisely.
scraping
Posted: February 2nd, 2007, 5:43 pm
by PaulS
manos wrote:PaulS wrote:What type of noise? Thumping, bumping, scraping?
Make sure that the Slides are aligned with eachother precisely.
scraping
Check to make sure all the wheels are running on the plastic tracks, along with the aligning mentioned earlier.
If you pull the whole machine and carriages to one end and let it go, does it occilate back and forth and stop in the middle, or get hung up along the way?
If it's not obvious, give C2 a call and they probably have some more methodic diagnostic procedures.
Posted: February 3rd, 2007, 1:23 am
by manos
PaulS wrote:manos wrote:PaulS wrote:What type of noise? Thumping, bumping, scraping?
Make sure that the Slides are aligned with eachother precisely.
scraping
Check to make sure all the wheels are running on the plastic tracks, along with the aligning mentioned earlier.
If you pull the whole machine and carriages to one end and let it go, does it occilate back and forth and stop in the middle, or get hung up along the way?
If it's not obvious, give C2 a call and they probably have some more methodic diagnostic procedures.
Thank you very mach I go to follow your advice
Regards from Ctete_Chania
Manolis