Page 1 of 1
New Monitor pickup does not record data?
Posted: May 14th, 2020, 7:43 am
by serjio
HI Just replaced the pickup on my partners model C and it does not record any data. When she starts to row the PM5 illuminates but that is all. I have swapped over the PM5 from my D (to see if it was he PM5 that was faulty) and that is the same.. her PM5 also works with my D. Not a difficult task to fit or too teckie so cannot see what I can have done wrong.
Any ideas?
Re: New Monitor pickup does not record data?
Posted: May 14th, 2020, 10:31 am
by Citroen
Is the PM5 configured for the right model?
Check the product ID page.
Re: New Monitor pickup does not record data?
Posted: May 14th, 2020, 6:55 pm
by Carl Watts
Update the firmware on your monitors using the latest update utility found here.
https://www.concept2.com/service/monitors/pm5/firmware
Then this makes it very easy to change the type of rower your putting the monitor on.
From the main menu press
more options>Utilities>more utilities and then select the Erg Type.
Re: New Monitor pickup does not record data?
Posted: May 15th, 2020, 1:34 am
by jamesg
My old C had a 2-wire sensor with PM3, and C2 wanted to know where the PM5 would go, when I switched.