Concept2 Forum

I have a wattbike pro, when i start cycling the screen turns on, but nothing else happens.
It doesn't display any signals about right-left difference or how hard i'm cycling etc.
So, the monitor isn't receiving any signals at all. What could be the problem? And how can i fix it.

The following steps have already been tried:
* Set to zero state
* Reinserting and removing plugs on the circuit board.
* Updating the software

WattBikes are not made by Concept2.

https://support.wattbike.com/hc/en-gb

I repair these for New Zealand, contact me for more information.

You will need some electronics skills to component level repair on the board.

Carl Watts wrote: ↑

May 2nd, 2024, 6:01 pm

I repair these for New Zealand, contact me for more information.

Seems only right to me... ; )

Carl Watts wrote: ↑

May 2nd, 2024, 6:01 pm

I repair these for New Zealand, contact me for more information.

You will need some electronics skills to component level repair on the board.

Hi, just joined this forum as I have the same issue, any chance you can give me some advice on how to fix?

Much appreciated
Nash