Concept2 Forum

Posted: **September 21st, 2006, 4:19 am**

Model D, PM3 with V97 firmware.

I set-up the following variable intervals

3000m 4:00r 0:00.0 pace boat
2500m 4:00r 0:00.0 pace boat
2000m 0:00r 0:00.0 pace boat

I set off a bit briskly for the 3K and completed it. Rested 4mins. Then set off on the 2500m and gave up after 373m.

The aborted interval doesn't show up on the logcard. BUT, the metres from it were added to my lifetime total on the logcard.

Here's the rows from the spread sheet:

Code: Select all

10:50.9	3000	31	179					01:48.4	1243	274			
				10:50.9	3000	31	179	01:48.4	1243	274			
											04:00.0	10	107

I can send an *.lcb if you need it.

Posted: **October 5th, 2006, 6:16 pm**

I've re-created this error on a different set of variable intervals.

Rowing variable intervals; 4*1K 5:00r and stopping with ~700m to go during the fourth interval.

Another symptom of this anomaly; is that this generates a LogCard error when I read the card with my OmniKey smartcard reader and LCU V4.04.

Concept2 Forum

PM3 V97 variable intervals anomaly

PM3 V97 variable intervals anomaly