Page 1 of 1
Posted: February 23rd, 2006, 7:36 pm
by [old] bbsportz
Mark,<br />We've just implementing the Force curve data in an application. Thanks very much it looks great.<br /><br />The manual says that we are looking at "Data samples proportional to FORCE".<br /><br /><br />Could you tell us specifically what this number is derived from .<br /><br /><br />Cheers<br /><br />The Two Marks
Posted: February 23rd, 2006, 8:23 pm
by [old] c2scott
The force curve is derived from force calculations based on flywheel acceleration. I think what you might be asking for is the specific forumlas or units, and this information will remain unpublished. It is not important what the force is, just that you can see the curve to improve your rowing stroke.
Posted: February 24th, 2006, 1:13 am
by [old] osborne
Are we to assume that the formula used is linear?<br />i.e. is a force value of 300 twice the value of 150 force units?<br /><br /><br /><!--quoteo(post=56931:date=Feb 23 2006, 07:23 PM:name=c2scott)--><table border='0' align='center' width='95%' cellpadding='3' cellspacing='1'><tr><td><div class='genmed'><b>QUOTE(c2scott @ Feb 23 2006, 07:23 PM) </b></div></td></tr><tr><td class='quote'>The force curve is derived from force calculations based on flywheel acceleration. I think what you might be asking for is the specific forumlas or units, and this information will remain unpublished. It is not important what the force is, just that you can see the curve to improve your rowing stroke.<br /> </td></tr></table><br />
Force Plot Curve
Posted: January 14th, 2009, 1:59 pm
by Robt.Lee
I have not been able to get the Force Plot Curve data, or HR data
using 1A 03 6B/6C 01 21. What is the correct command?
Re: Force Plot Curve
Posted: February 2nd, 2009, 11:50 pm
by Chris Brett
Robt.Lee wrote:I have not been able to get the Force Plot Curve data, or HR data
using 1A 03 6B/6C 01 21. What is the correct command?
I have always used 1A, 03, 6B, 01, 20 and it works fine for me. What error are you getting?
Have you got this to work correctly using the PM SDK Test APP? That is always a good place to start. If you set the app to resend/repeat then you can see the response data being returned as well.
Good luck Chris