Page 1 of 1
CODE 50 DRAG FACTOR ON PM4 MONITOR
Posted: April 29th, 2009, 11:14 am
by betista
Machine only 45days old and monitor last 2 of 3 workouts showing some bad data about 1/2 - 3/4 way through row. I got a CD 50 Drag Factor...Worked out yesterday no issue. Advised to call C2 Tech...anyone had this before?
Posted: May 5th, 2009, 5:27 am
by c2scott
Betista:
Code 50 means that something is not allowing the monitor to compute the drag factor correctly on multiple consecutive strokes:
- Fan is still wrapped in plastic wrap
- Too high a stroke rate (does not run down enough)
- Wrong model tyhpe (check the "Product ID" page and make sure it says "Model D/E" if you have a Model D or Model E
Feel free to email me directly if you continue to have problems.