I got on the erg today for the first time in a long time and I have no HR readout on the PM3.
I do have a readout on my wristwatch, so I know that the strap is working.
Any suggestions?
Thanks,
Mark
No HR readout on PM3
-
johnlvs2run
- Half Marathon Poster
- Posts: 4012
- Joined: March 16th, 2006, 1:13 pm
- Location: California Central Coast
- Contact:
I duct taped a piece of pvc sticking straight up from the front middle of the handle then wrapped the wrist receiver around this.
After using the monitor, I removed the pvc, made an angled cut so the wrist receiver lays at an angle, and replaced it on the handle with the duct tape.
I have used the monitor quite a few times this way and either way works quite well.
After using the monitor, I removed the pvc, made an angled cut so the wrist receiver lays at an angle, and replaced it on the handle with the duct tape.
I have used the monitor quite a few times this way and either way works quite well.
bikeerg 75 5'8" 155# - 18.5 - 51.9 - 568 - 1:52.7 - 8:03.8 - 20:13.1 - 14620 - 40:58.7 - 28855 - 1:23:48.0
rowerg 56-58 5'8.5" 143# - 1:39.6 - 3:35.6 - 7:24.0 - 18:57.4 - 22:49.9 - 7793 - 38:44.7 - 1:22:48.9 - 2:58:46.2
rowerg 56-58 5'8.5" 143# - 1:39.6 - 3:35.6 - 7:24.0 - 18:57.4 - 22:49.9 - 7793 - 38:44.7 - 1:22:48.9 - 2:58:46.2
Re: No HR readout on PM3
Make sure that the plug to the monitor is in all the way. One time when mine did not register anything, I found that the plug was just a couple of millimeters short of being pushed all the way in.M_Keating wrote:I got on the erg today for the first time in a long time and I have no HR readout on the PM3.
I do have a readout on my wristwatch, so I know that the strap is working.
Any suggestions?
Thanks,
Mark
Also, make sure that there are no other appliances around that might cause interference with the radio signal.
Bob S.