Concept2 Forum

Hello

I noticed some rust forming around the flywheel axle that extends into the grey frame itself.

There is no rust on the 14 tooth sprocket, but the piece of axle (the piece of tubing) that holds the sprocket has some rust.

I know how to take off the flywheel according to the instructions here: http://www.concept2.com/files/pdf/us/in ... emoval.pdf


but on the opposite side of the frame which holds the axle in place, there is a black cap, bearing cover, once removed, a bearing with a nut is exposed.

See schematic here: http://www.concept2.com/files/pdf/us/in ... ematic.pdf

if I remove nylock axle nut on both sides of the flywheel, will the axle just pop out easily?


I figured I'd ask here before I attempt anything (the rower works 100%, and there is no rust on the sprocket, but I figured I should clean or replace the axle at some point)


I have attached a picture

thank you!

Yes it should. You might want to consider purchasing the quiet kit retrofit from C2. It comes with a new axle, sprocket, chain and idler bushings and shock cord. I retrofit my model C and it is like a new, and very quiet, machine. It feels very smooth now. Good luck - JP

seedyeh, If it ain't broke don't fix it. If it's running well some rust on the flywheel axle isn't going to cause problems. Oil your chain now (it looks pretty dry) and apply some oil or grease to the axle to stop the rust from getting worse. C2JonW