Attention - The sensor is Damaged message after Firmwire update
Posted: May 24th, 2025, 4:35 pm
Hello!
I have a Concept2 Rower from sept 2005 (just bought it)
I did the PM5 Firmware update (vo 459.01 - model 130. ) yesterday from my ErgData as suggested by the app...
The Firmware update was successful but since then, I have an error message each time I turn on the PM5 for the first rowing session: Attention - The sensor is Damaged (ground cable) please contact Concept2 for replacement...
Then, I disconnect my app, reconnect and push again just row and it works and tracks perfectly all my data...
I think it seems to be more of a bug since I can use the rower after reconnecting the PM5 to my ErgData after this error message.
Nevertheless, this is annoying, do you have any solutions for me ?
Should I reverse the update to the previous firmwire ?
thank you
I have a Concept2 Rower from sept 2005 (just bought it)
I did the PM5 Firmware update (vo 459.01 - model 130. ) yesterday from my ErgData as suggested by the app...
The Firmware update was successful but since then, I have an error message each time I turn on the PM5 for the first rowing session: Attention - The sensor is Damaged (ground cable) please contact Concept2 for replacement...
Then, I disconnect my app, reconnect and push again just row and it works and tracks perfectly all my data...
I think it seems to be more of a bug since I can use the rower after reconnecting the PM5 to my ErgData after this error message.
Nevertheless, this is annoying, do you have any solutions for me ?
Should I reverse the update to the previous firmwire ?
thank you