Concept2 Forum

Hi,

I would like to share my experience on my last purchase.
I bought a rower model C with a PM2 (Rev 2.1).
This monitor had a a problem due to leaked battery.

I have dismounted It It and cleaned with a special spay (Loctite 7039) for cleaning electrical contacts exposed to moisture or other contaminants.
The monitor work fine..

I put varnish on damaged eletronics tracks. You can use nail polish or special electronic varnish.
My PM2 remains sensitive to humidity but works (My rower is in my garage.
I remove my monitor after each session.

I hope i can help rowers who have the same problem.

I think, i will buy a PM5 model in somes mounths

You can search this forum for some repair information but now having repaired a few hundred PM2s I can tell you your probably going to get that error come up again.

Indeed, the E011 error came back after a session in my wet garage.

I put my PM2 into my oven during 15 min in 60°C.

The E011 Error disappeared.

I am surprised about the price of the PM5 monitor in France. it's more expensive than neighboring countries.

215€ (in italy, Spain), 190€ in Switzerland, 245€ in France

Lebidartar64 wrote: ↑

June 15th, 2020, 9:35 am

215€ (in italy, Spain), 190€ in Switzerland, 245€ in France

It's GBP£155 (EUR€172.70) here in Inner Pomgolia. What's stopping you getting one shipped from one of your European or EEA neighbours - I thought that was what the single market (that we're leaving in December) was all about?