Page 1 of 1
PM2/3/4 on Model B
Posted: December 7th, 2013, 7:12 am
by devix
Hi everyone,
I bought a Model B without any monitor and I would like to install a PM2/3/4 (used one).
What kind of supply do I need other than the monitor?
Thank you
Re: PM2/3/4 on Model B
Posted: December 7th, 2013, 10:19 am
by devix
I found this one
http://shop-uk.concept2.com/index.php?i ... er=product
Do you think it should be enough to install it and a PM3/4?
Re: PM2/3/4 on Model B
Posted: December 7th, 2013, 6:00 pm
by Bob S.
There is some mounting hardware required. The US C2 site doesn't seem to list it any more, but they probably still stock it. I think that your best bet is to call C2 directly or email them at
info@concept2cts.com
Bob S.
Re: PM2/3/4 on Model B
Posted: December 10th, 2013, 6:04 am
by domdv
To install a PM2/3or4 onto a Model B rower you would need the specific bracket listed as:
Model B PM(X) bracket (insert pm number where the X is)
and you would also need the pickup sensor as shown in the earlier post, finally make sure that the flywheel still has the set of 3 magnets which circle the central hub, which is how everything is calculated.
I hope this helps.
Regards
Dom DV
Re: PM2/3/4 on Model B
Posted: December 20th, 2013, 5:36 pm
by devix
Thank you for your replies.
Actually, I was close to buy a Model B when I realized it wasn't an original C2!!! Fortunately I figured it out in time.
Finally I found a pre-owned Model D with PM3 at the right price (I hope because in Italy is impossible to find a used C2!!!)