pay attention to your finger!

[icedevil]

I'm cleaning my dynamic rower and I cut my finger with the aluminum rail of the seat. Pay attention! Is it normal for the safety? I think it is a design mistake...

[Cyclist2]

That sharp edge is a manufacturing effect of the industrial sheet metal cutting machinery. Not a design defect.

Take a small file or sandpaper block and just smooth off the sharp edge.

[icedevil]

Yes but in my opinion its better to do a curve like the rail in the bottom for the feet

[icedevil]

And i think that for 2600 euro the quality of the assembly is very poor

[estragon]

And i think that for 2600 euro the quality of the assembly is very poor

That's a lot to pay. Where are you? Even in Switzerland, where everything is more expensive, it's 1,525 CHF, or about 1,400 Euro.

[Citroen]

Yes but in my opinion its better to do a curve like the rail in the bottom for the feet

Write an email to Concept2 USA rowing@concept2.com with your concerns.

[Ombrax]

That's a lot to pay. Where are you? Even in Switzerland, where everything is more expensive, it's 1,525 CHF, or about 1,400 Euro.

He did say that his is a Dynamic. Is 1,400 the price of a standard or a dynamic?

[estragon]

That's a lot to pay. Where are you? Even in Switzerland, where everything is more expensive, it's 1,525 CHF, or about 1,400 Euro.

He did say that his is a Dynamic. Is 1,400 the price of a standard or a dynamic?

Dynamic --- https://shop-ch.concept2.com/gb/indoor- ... rower.html. The standard D is about 1100 CHF.

[Ombrax]

About all can say relative to this thread is that in my experience all the C2 products I've used personally (Models C, D & E ergs and a Dyno) have been of very high design and build quality.

[icedevil]

sorry, is 1600 euro

i had a model d before the dynamic and i think is better quality