Could someone who owns a model d with erg slides take a measurement of the floor space required? I just picked up a rubber Mat to protect the hardwood in the new room the erg is going to be used in.
The mat is 4ftx10ft. I know the website says 11ft of room required but is that the actual floor space covered or the room needed at the catch and finish?
Hard dimensions of model d on concept2 slides?
Re: Hard dimensions of model d on concept2 slides?
The slides do extend for 11', but there is an 18" gap between them. It might be possible to cut the mat in half and put one half under each slide. It would still be a bit close with only an extra 3" available on the half length mats, i.e. they would extend only 1 1/2" beyond the ends of the slides. There is not likely to be any slipping, so once everything is in place it would work OK.sayn3ver wrote:Could someone who owns a model d with erg slides take a measurement of the floor space required? I just picked up a rubber Mat to protect the hardwood in the new room the erg is going to be used in.
The mat is 4ftx10ft. I know the website says 11ft of room required but is that the actual floor space covered or the room needed at the catch and finish?
Bob S.