Model E - Potential Axle Problem

KipperTheDog · Post by **KipperTheDog** » August 18th, 2011, 2:32 pm

Hi,

I've got a Concept2 Model E Rower. Can anyone tell me if the drive axle should look like this? I was concerned about the gap/join that is visible... I'm hoping its not a crack.

Image attached at the following TinyPic URL - the gap/join is highlighted in the red box.

http://i56.tinypic.com/2saclj4.jpg

Hopefully its completely normal.

Thanks,

Andy

c2jonw · Post by **c2jonw** » August 18th, 2011, 3:53 pm

Andy- It's normal. The groove is used as a witness line to identify the specific vendor of that part.......C2JonW

KipperTheDog · Post by **KipperTheDog** » August 18th, 2011, 4:00 pm

Thanks - is it also okay that the bingee cord "just" touches the axle... again as highlighted in the red box?

c2jonw · Post by **c2jonw** » August 18th, 2011, 4:09 pm

Yes, that looks normal as well.....C2JonW

Concept2 Forum

Model E - Potential Axle Problem

Model E - Potential Axle Problem

Re: Model E - Potential Axle Problem

Re: Model E - Potential Axle Problem

Re: Model E - Potential Axle Problem