Concept2 Forum

OK - I'm a bit behind the times but this is GREAT. The firmware updates were a PIA. Yes, this was added a while back. But agreed, this was a great addition. As somebody who doesn't normally run Windows or Mac, it was definitely a huge PITA. Now I just need ErgData on my phone. Done all the updates ...

Referencing C2D parts schematic, there are two chain idler pulleys (part # 1024) in the ‘cat’s cradle’ of the chain drive and return mech. The one yoked to the bungee takeup presents no problem ime. The pulley nearest to the fan axle has been known to throw the chain on to the idler shaft (part # 1...

Let the chain pull your hands forward, during the recovery, rather than trying to push it; it has to stay tight. I think the chain stays tight. There's a tension in the chain on the whole recovery period and I don't push it. Maybe it's not obvious from the video, but there is never a slack on the v...

My two months old Model D erg makes an occasional knocking sound at the extreme end at the catch position. I think this basically only happens when I overcompress, so I am not very worried about it. I take it as my over compression warning. ;-) I was finally able to trace it to the chain hitting the...

I've seen weirdness syncing just today. I did 2x2500m/2min rest, set up properly on PM 5 with latest firmware, but it ended up totally bungled up in ErgData with multiple overlapping intervals and online logbook now says I did 7x5000m (but the total distance is 5000 and rest distance in between was ...