Concept2 Forum

Have tested the pickup 110ohms magnets barely hold a paper clip
Looks like a new unit or a repair where’s best in the UK???

Thanks for the replies
All the buttons operate as they should, when you say 105 ohms is this when a magnet is present or not? Going to strip it down again today and have a look at the magnets etc
Will keep this post updated as to what’s happening

If there is an output from the flywheel

It doesn’t respond to inputs from the flywheel

Have now checked the board for corrosion and there is none. Infact the inside looks new, checked the jack plug socket and this looks aokay no splits plug fits snugly. How can I check if there is a signal from the pickup? I do have a multimeter and various connectors but what am I looking for amps oh...

Thanks for the quick reply
The Firmware version is 311 and the hardware version is 321
I’m just going to pull it apart again to look behind the rubber pad
Is it possible to replace the magnets if they are very weak
Cheers Andy

Hi All i hope someone can help, i have picked up a concept model C with a PM3 on it, however the pickup cable was broken so i have replaced the pick up and put new batteries in the PM3 but it just reads zero's!!! i have checked that it is set up for a model C and looked at the and cleaned the circui...