Concept2 Forum

I have an older Model D, probably 2003 that has the blue color slide. An area near the back legs is rusted and I want to sand paper the rust and touch it up with some spray paint. Just trying to figure out what’s the closets match of spray paint at Home Depot. They have a royal blue and a cobalt.

I just bought a used model D And the flywheel plastic cover is very discolored yellow-ish. Does anyone know of any way to get this looking back to its original color I assume it’s Sun damage.

Looking to buy your no longer needed PM3 or PM4 working monitor.

I'm in Boston, MA.

Thanks.

What's the pickup wire?

Thanks! At work right now but will try what you said when I get home.

About the flywheel magnet, is that something I could replace myself? Do you need to order a new flywheel?

I have a model D build 2009, the PM3 was working intermittently in which it turns on no problem, but would register zeros. So I swapped it out with another PM3 I know has no issues and it did same thing. I then swapped out the sensor coil and it seemed to improve a bit but still acting up (please se...

can you provide a link of the exact LCD screen I would need to replace with? Is it easy to swap out? Plug and play?

I just bought a used rower with PM3. I noticed the LCD screen was a little off center so I took the battery cover off and tried to gently push the screen down from the inside with a screen driver (I know stupid) and it immediately caused a blank missing vertical line exactly where I pushed down on. ...

Anyone in the USA have a working PM2 laying around collecting dust that they would like to get rid of?

Find any sellers yet? I'm looking to buy a PM3 as well. There must be a bunch of them out there for all the folks that upgraded from PM3 to PM5's.

PM sent

Or can you just swap a PM3 on it? I know the PM5 requires a retrofit kit.

The monitor turns on but there are large blank stripes across most of the screen. I see that you can buy a new LCD for the PM3 for $28. Does anyone think that would fix this problem? Or do you think I need to replace the PM? My understanding is that the PM may have gotten water damage. If I need to ...

I lubricated the chain roller inside the frame. Didn't fix it.

The chain looks fine to me. No kinks. Each link is moving on its own.

The one way bearing, is it easy to get to? Can I put chain oil on it or should I use some kind of grease?

All those things look good to the eye. I'm thinking it may be some kind of ball bearing issue. Just don't know how to attack it.